Smart-Photo Control

This device monitors the main parameters of each light point: current, voltage, power factor, active power, among others. This data is sent wirelessly providing the history of consumption and fault report of the luminaire for its timely intervention.

The device allows control of on and off of the luminaire, as well as dimerization; Use of the lighting sensor by programming.

The system has an application that allows the control and evaluation of the system, is divided into groups or zones and allows the generation of detailed reports on the percentage of connection to the network or the report of failures. The execution of the maintenance activities and the configuration of the system is carried out in stages to avoid the saturation of the system.

 

Adding the census accessory to the luminaire can add the following functions

  • Temperature protection system, avoiding that the LEDs reach the levels set as critical, the device is in the ability to attenuate the illumination for its own protection.
  • Sensor of movement, allows attenuation of the luminaire when no presence is detected, thus generating a considerable reduction of electrical consumption.

Technical characteristics

  • -Food: 85 to 265 Vrms
  • -Protection against overvoltages
  • -Maximum managed power: 240W
  • -Communication frequency: 868 to 915 MHz
  • -Operating temperature: -25 ° C to + 75 ° C
  • - Controlled parameters: Active power, current, voltage, power factors.
  • -Precision law +, - 2%
  • - Voltage requirement +, - 2%
  • -Display control: SPST dry contact
  • -Protocols attenuators managed 1-10V, PWM
  • - Dielectric strength: 5KV minimum
  • -Ground protection: IP54

© Electrobiomedical S.A.S